Garage doors rarely fail at a convenient time. If you need Genie opener circuit board replacement in Clovis, CA, we can often come out the same day when a technician is available. Failed logic boards and receivers replaced, often after a power surge. We work on Genie garage door openers of every age, from older models to current lines, and carry or can source compatible parts. Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.
Is it time for Genie opener circuit board replacement?
- The opener is completely dead even though it has power
- It worked until a storm or power surge
- Random operation or no response to any control
- Diagnostic lights showing a board fault
Common causes
- Power surges and lightning
- Heat and moisture damage
- Age
Safe checks before you call
- Reset the breaker and try a different outlet.
- Unplug the opener for a minute, then plug it back in.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
What happens during the visit
- Confirm power and rule out sensors and controls
- Replace the logic board or receiver
- Reprogram remotes
- Set the limits and force
- Recommend surge protection
On older openers, a new opener can cost about the same as a board and adds current safety and security features.
Genie Opener Circuit Board Replacement cost in Clovis, CA
What moves the price:
- Drive type: chain, belt, screw or wall-mount
- Whether the fix is a part or a whole new opener
- Remotes, keypads and smart accessories
- Ceiling height and rail extensions
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Other Genie services
- Genie Garage Door Opener Repair
- Genie Garage Door Opener Installation
- Genie Smart Garage Door Opener Setup
- Genie Remote & Keypad Programming
- Genie Garage Door Sensor Repair
- Genie Opener Gear & Sprocket Replacement
Local Genie opener circuit board replacement for Clovis, CA
Outages are common in California during heat waves and planned power shutoffs, which is why a battery backup on the opener matters here.
California law (SB 969) requires garage door openers sold or installed in the state since July 1, 2019 to have a battery backup, so the door still works during a power outage.
Besides Clovis (ZIP codes 93611, 93612, 93613 and 93619), we handle Genie opener circuit board replacement in Tarpey Village (2.2 mi), Old Fig Garden (5.9 mi), Fresno (6.6 mi) and Sanger (11.5 mi). Call (833) 435-8883 to book a visit in Clovis.
Genie Opener Circuit Board Replacement: frequently asked questions
How much does Genie opener circuit board replacement cost in Clovis, CA?
Genie Opener Circuit Board Replacement typically costs $175-$400 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do Genie opener circuit board replacement the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is Genie opener circuit board replacement covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Genie warranty terms vary by product and age. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where California or Clovis requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my opener?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.